EZRide+ Assembly Instructions
Patent Pending
** SEE VIDEOS BELOW **
EZRide Mount to Wheelchair
EZRide Mount and Dismount
Tow Bar Removal from Folding Chair
Tow Bar Extension Installation
Brake Handle Adjustment
EZRide Brake Replacement
The above image shows how much space is required when installing the mounting bracket to your wheelchair, whether vertically or horizontally. The clips that come with the EZRide+ (shown here) will work on wheelchair tubes up to 26mm (1.024 inches.) in size.
The images above show the EZRide+ installed on a Journey So Lite wheelchair using the Tow Bar Extension and the Handle Bar Extension Accessories.
The images above show the Tow Bar and EZRide+ installed on a Feather Chair wheelchair.
EZRide+ Butterfly Tow Bar Clips
-
Stainless steel construction.
-
Tubing up to 36mm (1.4 inches).
-
Won’t work if wheelchair tubing is larger than 36mm (1.42 inches).
-
Allen screws can be removed and replaced with larger M8 screws (not included) greater than 50mm (2 inches) in length. Allows clips to work on wheelchair tubes larger than 36mm (1.42 inches).
Use the Butterfly Tow Bar Clips for wheelchair models:
-
Tilite aeroZ
-
Tilite ZRA
-
Invacare Crossfire
-
Quickie GT
-
Kushall AirPro
-
Strongback models 24, 24AB, 22s, and 22sAB
EZRide Adjustable Handle Bar Neck
-
Aluminum construction.
-
Increases the reach of the handle bars.
-
4.375in extension with 180 degrees of adjustability.
EZRide Tow Bar Extension
-
Constructed from 2mm (.08 inches) thick stainless steel square tubing.
-
Configure for a 3 inch or 6 inch extension.
EZRide Struts
-
1 inch/25mm diameter tubes.
-
6 inches long.
-
Mounted on frame members for when the tow bar is too wide, even when fully collapsed.
-
Extends EZRide further out from front of the wheelchair.
-
Pin stop ensures the tow bar clamps will not slide off.
-
Can be mounted on wheel chair frames up to a diameter of 38mm/1.5 inches.